OK, common problem where the battery disconnect resets the immobilizer. Try leaving the car and ignition switch to ON for a half hour. This often resets it or it resets overnight. It shouldn't be activated by disconnecting the battery and this trick usually resets it. L. Pop the panel off the driver's end of the dash (fuse panel C). The first column may or may not have three sideways turned fuses on it. If so, then fuse 16 is a 40A that supplies power to the starter relays. If everything is going right, the starter relays activate at the command of the ECM to pass this 12v on to the starter. It is simple to turn off the immobilizer if you have a car key – just insert the key into the car accessory slot. Allow the key to sit in place for 15 minutes before allowing the immobilization unit to identify it. If the immobilizer light detects that the key is incorrect, you can use it to determine if it is faulty. The only way to disable the anti-theft system from ever working again would be to find a comment that can custom build a new PCM that has the circuit board designed to not have anti-theft. There is not a Ford approach to disable it. You can contact one of these companies. 2. Increased Risk of Theft. Bypassing the immobilizer system exposes your Dodge Ram to a higher risk of theft. Thieves are constantly looking for vulnerabilities, and bypassing the immobilizer sends a signal that the vehicle’s security is weakened, making it a prime target for theft. 3. To disable the alarm on a Hyundai Getz, you just need to bypass the hood switch. The alarm circuit thinks the hood is up and will not go into the Arm state. The switch connects the single wire connected to it to ground when the hood is up. So you can just connect a wire from the back of the switch to ground. 3KKj.

how do i disable immobilizer